If purchasing
monitors…the following guide will help you get the most out of your new monitors!
Basic instructions for using the monitors. Separate the
left and right monitors. With your right hand, hold the right earpiece so that
the cable points towards the ground. Now, pull up the pinna (outer ear) while
inserting the canal tip of the earpiece into your ear canal. Slowly rotate the
earpiece into place. The earpiece should almost seem to snap into place. The
cord has a soft wire in the portion leading up to the ear piece. This allows
you to manipulate the cord so that it bends up and over your ear similar to
the ear-hook on a pair of eyeglasses. Tuck the cord around your ears.
Ways to care for and
maintain monitors.
The following are a few
simple guidelines that can greatly increase your listening enjoyment and the
life span of your monitors. · Wipe the earpiece with a soft cloth after each
use.
· Do not expose your monitors to temperature extremes (i.e. car dashboards
in the summer).
· Never immerse your monitors in water. Never attempt to clean the ear canals
with water! · Prevent strong impacts to your monitors (i.e. dropping or sharp
blows).
· Always store your monitors in the provided case · Never use anything to
probe into the sound bore of the monitor. Regularly check your monitors for
earwax. To remove excess cerumen (earwax) from the end of the sound bores,
carefully use a pin and insert it into the canal to clear wax away.
· Do not use the cord to remove the monitor from your
ear. This will damage the wire.The helix should be
freed from your ear first.The outside should be clean only with a soap and
water solution or rubbing alcohol.
Keeping your monitors
clean and in a safe environment will give you years of hearing satisfaction!
C1000’s
,C2 & C3 users do not remove cords after use.
This should only be done when needed…doing so will eventually loosen the plug.
